Matrox G200 MMS w\tuner

[MCD4x4]

HI,

I recently had to format and reload. I'm using a Matrox 4 monitor cars with TV tuner. I downloaded the graphics card software without a hitch. I down loaded the PC-VCR software as well. The problem I'm having is when I click on the setup file, it starts to run it's coarse, gets to the "preparing to install" part and just disappears. I tried downloading the setup file again and I still have the same problem. everything else is running fine. Any idea? Thanks.

Brian NY

[-pops-]

Are there any notifications in the Event Viewer after this happens?

[MCD4x4]

Hi,

I tried it right after I read this post and found these errors on this date. Here's what it says under system:

ERROR: The Matrox capure/crossbar diiver failed to start due to the following error:

The service cannot be started, either because it is disabled or because it has no enabled divices associated with it.

ERROR: The browser service has failed to retrieve the back up list too many times on transport \Device\NetBT_T cpip_{F9D80804-9157-4AC8-8741-27DE108EAECD}. The back up log has stopped.

WARNING: The browser master was unable to retrieve a list of servers from the browser master \\YOUR-6BVPXZTOQ on the network \Device\NetB_T cpip_{F9D80804-9157-4AC8-8741-27DE108EAECD}

under Application:

ERROR: Falt bucket 02096553

ERROR: Hanging application rundll32.exe, version 5.1.2600.0,hang modul hungapp, version 0.0.0.0, hng address 0x0000000.

I have no idea what all this means but I hope you do. Thanks.

Brian NY

[MCD4x4]

I'm falling down the list here guys, Anybody?