Jump to content

Stairway to heaven


CurlyWhirly
 Share

Recommended Posts

It,s not a bad as it looks. I do that occasionally with Amateur Radio Repeater masts.

I have to go up and check the Ariel's,sometimes replacing them, put new coax cable onto them and put shrink-wrap sleeving around the PL259 connectors.

Building them is the worst job. You can be 80 to 100 meters up hanging by a single rope attached to a nylon safety harness with a helicopter above you with a five meter section dangling under it, then you have to manoeuvre it into place by giving the pilot directions through a headset then start bolting it into place. All this with the chopper giving off a 60 MPH down-draught. It takes day's to start from the bottom and finishing at the top. But I'm still here (I think). :unsure:

Link to comment
Share on other sites

It,s not a bad as it looks. I do that occasionally with Amateur Radio Repeater masts.

I have to go up and check the Ariel's,sometimes replacing them, put new coax cable onto them and put shrink-wrap sleeving around the PL259 connectors.

Building them is the worst job. You can be 80 to 100 meters up hanging by a single rope attached to a nylon safety harness with a helicopter above you with a five meter section dangling under it, then you have to manoeuvre it into place by giving the pilot directions through a headset then start bolting it into place. All this with the chopper giving off a 60 MPH down-draught. It takes day's to start from the bottom and finishing at the top. But I'm still here (I think). :unsure:

I am unhappy going up even a small ladder. I cannot even clean the upstairs windows.

Link to comment
Share on other sites

It,s not a bad as it looks. I do that occasionally with Amateur Radio Repeater masts.

I have to go up and check the Ariel's,sometimes replacing them, put new coax cable onto them and put shrink-wrap sleeving around the PL259 connectors.

Yes but not at 1700 ft :rolleyes:

I hazard a guess that if you went up there you would change your tune :P

Link to comment
Share on other sites

It,s not a bad as it looks. I do that occasionally with Amateur Radio Repeater masts.

I have to go up and check the Ariel's,sometimes replacing them, put new coax cable onto them and put shrink-wrap sleeving around the PL259 connectors.

Yes but not at 1700 ft :rolleyes:

I hazard a guess that if you went up there you would change your tune :P

I've been up to 800 feet. 800 or 1700 it wouldn't make a difference to me. I don't have a fear of heights.

Link to comment
Share on other sites

I've been up to 800 feet. 800 or 1700 it wouldn't make a difference to me. I don't have a fear of heights.

Oh right.

What 800 ft up a tower :0

I will say that most people would have a fear of heights especially when there is no safety harness ;)

Well the way I do it is to hook the Carabiner above me at arm's length then climb up till it's just below waist hight then fasten a second one again at arm's length then take off the one bellow and so on and so on till I get to the top then I hook them both on. I've never trusted just one since my Army day's.

Link to comment
Share on other sites

Being an ironworker of over 20 years,I will interject that 10 feet is no different that 1000 feet.It's not about how high you are,but more your level of confidence and competence.I have rarely tied off to the structures I have erected because it inhibits movement (duh!) and slows production.I have been ordered to tie off and have,but otherwise....

Skywalkers know that your best defense against misplaced steps or handholds is to never disrespect the spirit of the iron by exibiting an air of carelessness or bravado.

As it is,in the 20+ yrears I have never witnessed a serious or life threatening accident.I wouldn't have it on a site I'm working on.

That being my 2 cent,there has never been a more rewarding and exciting job to compare....

One Love

Link to comment
Share on other sites

  • 2 months later...
  • 2 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. Privacy Policy